SpankySouthport
Private Member
Do I need to sbr thermals?
Going to fully mesh just so I can sleep lol
Going to fully mesh just so I can sleep lol
@SpankySouthport if using Parex Monorex then put Microgobetis on aircrete blocks first.
Using weber ,there was no need for sbr mate ,full mesh i agree , weber would state rendaid which is for low suction ,ie smooth brick ,or if you have a large m2 and you want to kill the suction , then rendaid , which must be applied at least 48 hours before topcoat of monoDo I need to sbr thermals?
Going to fully mesh just so I can sleep lol
Spanky if it rains so what get it scraped !thats if its ready done some dashing in the rain the other day did it wash of?wasnt getting paid enough to look!lol !!
Using weber ,there was no need for sbr mate ,full mesh i agree , weber would state rendaid which is for low suction ,ie smooth brick ,or if you have a large m2 and you want to kill the suction , then rendaid , which must be applied at least 48 hours before topcoat of mono
Your be fine ,have you got the next day scratch ? thats the small tooth sharp one , go over it with that first ,then use your I section to take out any high points if needed ,walk in the park mate ,sleep well :RpS_thumbup:Cheers Keith, im bricking it just had a look at a few other posts about webber pral m!
Cracking!!!
Not gonna sleep tonight I can see it now!!
Don't want to ask this as it will play on my mind but, I started coating it at about 2 and finished about 4-4:30, I'm gonna get back there for 6am and give it a scratchier , is that to long? Is there anything I should watch out for or be aware of?
Cheers Ben
Spanky sounds like you might as well CAMP THE NIGHT there! 6 in the morning dont get paid enough for that go @ 8 if its hard just scrape harder! It will be fine ! Didn't want to go down accelerator route this time of year for same day scrape?
Had your partner never used it before either?
Did you get any halos?
Halos are when you rub through to the first coat if it's not on thick enough.