-
-
FreeD replied to the thread No bog brush.Gonna have to carry something in the van...worst i had though was a dump in a huge 2 million pound house old couple...1st floor toilet... -
Serves you right you bloody filthy animal.
-
I just use my brush fo cleaning whisk an stuff
-
Those square bogs are the worst ! All ledge with a small water hole right at the back ! Half a bog roll n push the skids down n flush as...
-
Some properties don't have a bog brush?? What the f*ck is with that? These are nice properties affluent areas... I always need a giant...
-
FreeD replied to the thread SBR not killing suction.Could be a bad batch or cheap import?
-
Just received the new mixer cant wait to get bk 2 work next week and give it a go
-
If you can put a pic up in about 15 years I’ll accept its better than a megamixer (y)
-
-
Tell the customer not to slam the door as it may bring the ceiling down!
-
FreeD replied to the thread Roughcast repair looks bad.Looks like the robbed some sand from a sand pit...
-
FreeD replied to the thread Roughcast repair looks bad.That ain't rough enough! Only one option...grow a creeper up it
-
They can’t get the staff down here :coffe: Put a long day in and nearly a 3hr drive before that. All good though mate. Will be raring to...
-
Did a job years ago, before trans was in the public consciousness, it was a big rough arsed plumber who had gone from him to her, what a...
-
FreeD replied to the thread SBR not killing suction.What brand of SBR?
-
I'd give it a 3/4mm pass with Reno, straighten it out a bit, then bead it with 6mm, and render with monocall spat mesh in the surface...
-
Just had all look it is cheaper thanks So 10mm beads 3mm renopass with mesh and top it with the other one Is the top coat a scratch...
-
FreeD replied to the thread Great News.
-
The counters are lower
-
-
Truley amazing transformation. Very inspiring
-
-
FreeD replied to the thread Great News.There's only one c**t on this forum and it sure ain't Vincey.
-
All site managers are jumped up yes men pricks! Your made for the job @Vincey
-
FreeD replied to the thread Roughcast Issues.Grow a creeper up it
-
FreeD replied to the thread Roughcast Issues.Looks rough
-
FreeD replied to the thread Plastering cost comparison.Looks smooooooooth X
-
FreeD replied to the thread Plastering cost comparison.Ha ha ho ho ho...
-
FreeD replied to the thread Plastering cost comparison.When I did my C&G we used box screeds and if you could slide a penny coin behind the straight edge at any point if was a hack off (by...
-
-
Loading…
-
Loading…
