Hi all,
I need some advice regarding some internal rendering.
Row of houses on my block has alot of rising damp.
I peeled off all the plaster, removed subfloor, cleaned area under floor, removed bricks and added damp proof membrane, used tanking slurry about half way up the wall and replaced subfloor.
Whilst rendering the walls with sand cement 4 to 1. The bottom half where I used tanking slurry all peeled away. I have no idea why . I pva'd the wall well. So I have peeled the bottom half of render again and was going to give it another shot. Any advice as to how I can do it differently?
I need some advice regarding some internal rendering.
Row of houses on my block has alot of rising damp.
I peeled off all the plaster, removed subfloor, cleaned area under floor, removed bricks and added damp proof membrane, used tanking slurry about half way up the wall and replaced subfloor.
Whilst rendering the walls with sand cement 4 to 1. The bottom half where I used tanking slurry all peeled away. I have no idea why . I pva'd the wall well. So I have peeled the bottom half of render again and was going to give it another shot. Any advice as to how I can do it differently?