hi to everybody,
i was hoping to obtain some information from you guys as i have very little experience with plastering in any of its forms,
i have just had an issue with two walls ,these were boarded out with thermal plasterboard and then plastered however the finished surface is easily damaged, to the extent you can damage it without much effort with your finger nail the finished surface does not seem to be very durable compared with the other walls in the room that are block work with solid plastering, this to the touch in comparison is very hard ,is it normal for the finish on plasterboard to be so soft/easily damaged and what would have been the type of plaster that was used, any information regarding this would be really appreciated .
thanks and regards
i was hoping to obtain some information from you guys as i have very little experience with plastering in any of its forms,
i have just had an issue with two walls ,these were boarded out with thermal plasterboard and then plastered however the finished surface is easily damaged, to the extent you can damage it without much effort with your finger nail the finished surface does not seem to be very durable compared with the other walls in the room that are block work with solid plastering, this to the touch in comparison is very hard ,is it normal for the finish on plasterboard to be so soft/easily damaged and what would have been the type of plaster that was used, any information regarding this would be really appreciated .
thanks and regards