Hi all, new to the site, and reading mixed responses and posts across the board, whats your thoughts on the emerging EWI industry and perceived rates for silicone topcoats and dashed finishes, using Wetherby's, Weber, Alumasc phenolic and EPS systems.
What would you be looking at for the following as an all inclusive rate, this isn't a cheap is best question as we all know you get what you pay for, and do you think the potential for skills retraining at no cost would be beneficial to the plastering industry to facilitate the current upturn in the industry?
Your constructive thoughts would be greatly appreciated
What would you expect a gang to get away in meterage for the the week based on the following and how much would be a a fair labour only rate.
Base Rail inc window and verge trims and Board =
Topcoat and Mesh =
Dashed finish =
Silicone Finish =
Prices to be fully inclusive of any accomodation costs.
Look forward to the colourful responses no doubt
Collo
What would you be looking at for the following as an all inclusive rate, this isn't a cheap is best question as we all know you get what you pay for, and do you think the potential for skills retraining at no cost would be beneficial to the plastering industry to facilitate the current upturn in the industry?
Your constructive thoughts would be greatly appreciated
What would you expect a gang to get away in meterage for the the week based on the following and how much would be a a fair labour only rate.
Base Rail inc window and verge trims and Board =
Topcoat and Mesh =
Dashed finish =
Silicone Finish =
Prices to be fully inclusive of any accomodation costs.
Look forward to the colourful responses no doubt
Collo