Recent content by spongebob

seems colour dependant but about 250 (y)

Once it has been primered and had a top coat it will be fine !

The crack is down the edge of the bead rigsby it looks like he has bashed the bead outwards whilst fitting the frame Rendit gear is the best chance you have got of mending it or i would be tempted to render a band over each side of the door to make a raised feature probly about 9 inches wide

Are you the fat one or the grumpy one ?:RpS_confused:

Minster at maidstone will be the best place to get krend ! Beads from G and H supplies near bean :RpS_thumbup:

Renderlath is a complete cock to render over and will probly need two coats of base to get it good enough to mono

Sorry i couldnt resist !:RpS_blushing:

Webber?

Phone krend and ask them to spec it for you :rolleyes)

Krend used to spec r7 to use on smooth concrete so i dont think it is just a sealer spunky , if you put the first coat of krend into it whilst it is still wet it all becomes one on the wall a bit like putting grit into it

Rx7 is similar to unibond in the way you would use it but much stickier and it will kill the suction, Ive used it over painted bricks with no problem but you are still relying on the paint sticking to the wall ,ive used it on smoth concrete aswell !

Krend do there own primer called rx7 ,You could apply that then put your two coats of krend on ! Its not as good as using a base coat but it works ! and probly comes out cheaper

Your Asian !:rolleyes)

Seems to be a bit blowing about anyone notice it