CeeVee
Well-Known Member
Ok so theres no manual to download for my EZE24 so I just went in blind and changed the mixing shaft....but did I do it right?
Unbolted the motor to expose the shaft
Around the shaft was about a centimetre gap that was filled with what I thought was old mono...but I'm pretty sure it was some kind of friction putty...it was soft and smelled of grease.
Anyhow I cleaned it all out, greased up the new shaft and popped it in.
Then I thought about the 'putty' which I had no idea about so I packed it all back in...right or wrong??
I've given it a quick test and all seemed to be working fine...
Unbolted the motor to expose the shaft
Around the shaft was about a centimetre gap that was filled with what I thought was old mono...but I'm pretty sure it was some kind of friction putty...it was soft and smelled of grease.
Anyhow I cleaned it all out, greased up the new shaft and popped it in.
Then I thought about the 'putty' which I had no idea about so I packed it all back in...right or wrong??
I've given it a quick test and all seemed to be working fine...