-
-
That the way I mainly use it, it goes better if the sbr is allowed acouple of hours to dry -
use their toothbrush. Takes a little longer. Charge day rate
-
www.CSD.com/etiquette-training
-
ChrispyUK replied to the thread No bog brush.Shut up Skiddy
-
ChrispyUK replied to the thread SBR not killing suction.Skimmed over bare plaster skim ceiling this week. Couple of thin coats of sbr and thin coat of pva. Like skimming plaster board.
-
Completely off topic but ok
-
-
If they ain’t got a bog brush I’d just leave the skiddies in the bog not my problem,I love taking a dump in customers toilets it’s like...
-
Smart arse !
-
ChrispyUK replied to the thread No bog brush.Well if you’ve spotted there’s no bog brush, just fold and put a bit of loo roll in the pan first. Helps keep it clean :coffe:
-
Gonna have to carry something in the van...worst i had though was a dump in a huge 2 million pound house old couple...1st floor toilet...
-
Those square bogs are the worst ! All ledge with a small water hole right at the back ! Half a bog roll n push the skids down n flush as...
-
ChrispyUK replied to the thread Half block work, half old plaster.You’re only going to be able to work to the flatness of the existing wall. A speedskim is not really the same as a feather edge when...
-
Don’t pva the block work just give a dampen down or mist of water Don’t let the hardwall dry overnight no amount of pva will kill the...
-
If you can’t get away with a bit of filler and sanding then yes you can pva and go at it again but put a few coats of pva on because...
-
ChrispyUK replied to the thread Roughcast repair looks bad.They can’t get the staff down here :coffe: Put a long day in and nearly a 3hr drive before that. All good though mate. Will be raring to...
-
Just be careful mate, you do know that you're a wanted man down that way ? (y)
-
ChrispyUK replied to the thread Roughcast repair looks bad.Working down in Bristol at mo mate. Just having a couple of pints
-
Walked out well up on the poker mate but ended up squandering the lot on a bunch of shiny new trowels in the next town ! When will I...
-
ChrispyUK replied to the thread Roughcast repair looks bad.I hope you enjoyed yourself
-
I see your Cookie Monster and I raise you a ghost thing with a rabbit sock puppet!
-
ChrispyUK replied to the thread Why is SBR not killing suction.Light blue one
-
-
Im having PTSD flash backs to @ChrispyUK ’s house diaries here! :frenetico:
-
That's a fair comment and I don't completely disagree. But in my case I am prepared to get better by doing, I have nothing to loose but...
-
I took a look today and I think i can save it (y) It's gonna take sanding and filling but that's the cost of learning. Will send a photo...
-
There's only one c**t on this forum and it sure ain't Vincey.
-
Mmmm...we came to the conclusion that taking the bins out was above your abilities and we didn't want to set you up to fail.
-
We did think about "adopting" you, oh how we laughed.
-
ChrispyUK replied to the thread Plastering over fresh plaster.It's a pity you wern't around a couple of years aback when the CHD was running.
-
-
Loading…
-
Loading…
