Parko
Member
Hi Lads, am fairly new to monocouche rendering , been puting on by hand for a few years but have recently been blessed with a g4 next gen from mr lord, so everything going fine however I need some advice , after starting a job this week all the block work is mono and the cuts told me he had weber rep out for spec on the dormas which was aquapanel=laccoat=mesh=mono however when I've got the spec sheet it's aqua=1laccoat=mesh=2laccoat=pr310primer=weberplast.tf problem is I've never used thin coat system before so looking for advice how to apply,ie how far back from the beads does the lac coat finish? Wots best way to apply Tf coat and how does it rub up as surely not going to be same finish as the mono, Soz for long post and thanks in advance for any advice