It's on painted render that's rock hard so going over top with meshed coat then parex scraped
I normally mesh coat/bucket coat dpr 1.5.done a few now
trouble is Wezly its a bit cold now for thin coat, at least with scraped its got half a chance, anyway its local authority so spec is parex scraped, done a krend tc 1.5 on my dormers last sat, it washed off on sunday night !:RpS_confused:Parex's acrylic top coat, 1.5mm grain.
Can't remember off hand but the start off on say 250 and go down.what you spraying it on @clivo? What finish you finishing it with?
Only nosey as I have used it a few times now
PERINTER not printer ( predictive txt :RpS_cryingsprayed printer on the ritmo today, speed 7 water 110, (started on water 200 was like piss) went like a dream :RpS_biggrin:
How think will your mono be clivo?
yes he did mate, he told me to put 4-5mm perinter and mesh cracks ( i fully meshed just to be cautious) followed by mono ,all on 15 mm beadsJust out of interest Did the local parex rep view the job then send you the spec clivo?
yes he did mate, he told me to put 4-5mm perinter and mesh cracks ( i fully meshed just to be cautious) followed by mono ,all on 15 mm beads
have you done over painted render before, didn't like the idea but was assured it would stickYeah I've used parinter on 4 jobs now and have full meshed.
have you done over painted render before, didn't like the idea but was assured it would stick