That looks as though it has been put on freehand and only finished with a scraper, no I section.
The expansion bead is unsightly and would have been better colour coded.
No easy fix to this one. Even a thin coat over the top won’t work, it will just follow the bumps and hollows.
Hats off to you for coming and laying yourself bare mate.Hi
Can anyone tell me why this Rendering looks so patchy?? What have a done wrong
Thanks Lee photo attached
Rigsby: Do you suggest that the render all needs to be taken off and restarted from scratch then?
How long might this take?
And can the beading be replaced with colour coded one if I do this?
Have u any picture wit sun off it
If that's the sun directly across it, I've seen a lot worse tbfHi
Can anyone tell me why this Rendering looks so patchy?? What have a done wrong
Thanks Lee photo attached
You maybe able to go over it with 10mm of render. But you may have to take the reveals off to make the frames look sensible.
i think you love plastering far 2 much.
I believe that NHBC guide says 45 minutes. That 15 minutes could make all the difference.I did comment saying it wasn't too bad with the sun across it but I just looked at the photo with the sun off and it's not clever either. Should look absolutely flawless for 99% of the day except for glancing light for half an hour which no one can beat.
No to be fair, I rendered my own house 8years ago and is probably worse than this. As you get more experienced with the materials the better you become.Hi
Can anyone tell me why this Rendering looks so patchy?? What have a done wrong
Thanks Lee photo attached
I doubt that many here would have experience of that situation to give you an accurate answer.Do you suggest that the render all needs to be taken off and restarted from scratch then?
How long might this take?
And can the beading be replaced with colour coded one if I do this?
use a serrated edge mate shows up any hollows when ruled then like dais I section it for a real flat areaDo you suggest that the render all needs to be taken off and restarted from scratch then?
How long might this take?
And can the beading be replaced with colour coded one if I do this?
Do you suggest that the render all needs to be taken off and restarted from scratch then?
How long might this take?
And can the beading be replaced with colour coded one if I do this?
that has been ruled with a serrated edge then I section mate
That looks absolutely mint.that has been ruled with a serrated edge then I section mate
I’m not sure the best way around it to be honest.Do you suggest that the render all needs to be taken off and restarted from scratch then?
How long might this take?
And can the beading be replaced with colour coded one if I do this?