krend job

[realtek]

Hi guys,

Had a krend job done and a stop bead was installed at DPC level with a belcast bead underneath and then also rendered below the DPC level.

The stop bead was set in slightly further to the wall and was rendered over and bell cast bead was left exposed.

Just wondered if thats normal practice or not? Heard water ingress could land on the bell cast bead and travel through to back of the render and cause it to all come off - whats your views?

Also renderer made some bits look s**t by patching up bits that went wrong

Cheers

 

[S a plastering]

picture

 

[Dansouthcoast84]

that doesnt sound right. if you were to use render under doc an expansion bead would be best.

need a pic.to see whats happening really

 

[Andy M]

Sounds terrible,patching won't look great,have you paid for the work?

 

[Mag]

@Mixy is this you.

 

[Danny]

Hi guys,

Had a krend job done and a stop bead was installed at DPC level with a belcast bead underneath and then also rendered below the DPC level.

The stop bead was set in slightly further to the wall and was rendered over and bell cast bead was left exposed.

Just wondered if thats normal practice or not? Heard water ingress could land on the bell cast bead and travel through to back of the render and cause it to all come off - whats your views?

Also renderer made some bits look s**t by patching up bits that went wrong

Cheers

needs a picture

 

[S a plastering]

think the beads have ended up flush with each other you could have used a 15drip beadthen for the plinth use a 6mm bead rendered with adhesive an just painted afterwards then a clear silicone between the two at the damp course

 

[Mixy]

@Mixy is this you.

Yes :-(

 

[realtek]

Will post a pic later, left with different colour panels on same sides too as they were all done a different times

 

[GrantyBoy]

Pic?

 

[Danny]

Hi guys,

Had a krend job done and a stop bead was installed at DPC level with a belcast bead underneath and then also rendered below the DPC level.

The stop bead was set in slightly further to the wall and was rendered over and bell cast bead was left exposed.

Just wondered if thats normal practice or not? Heard water ingress could land on the bell cast bead and travel through to back of the render and cause it to all come off - whats your views?

Also renderer made some bits look s**t by patching up bits that went wrong

Cheers

How did you get on with the pictures?

 

[spunky]

Have you got it the wrong way round was the bell at the top and the stop bead underneath?
As for what water could do it won't get into you're walls it's a myth