Coving

[S a plastering]

What methods would you adopt to make this piece up got roughly half day to do it

 

[BigK]

Half a day?

That's just bog standard coving isn't it?
(Trying to look at pic on my phone)

Tap out the stop end from the left, and a right hand internal mitre should slide right in there. Scribe the one on the right.
Obviously measure the length on the wall side.
Should be done and gone in an hour

 

[TonyM]

That's half an hours work. 10 mins sheet up and get hop up out. 10 mins do the job. 10 mins clean up and load van.

 

[A.plasterer]

charge half a day and get the other 2 to do it on hourly rate

 

[A.plasterer]

sorry chaps thought that was a thumb up lol, not swears

 

[S a plastering]

It's not a bog standard coving it needs working in it's about 6.5 inch radius so needs bonding out then skim

 

[S a plastering]

Haha I can piiss normal off the shelf stuff just wanted to know any different methods of bonding an skim a coving ta

 

[A.plasterer]

coving party at David and rachels 68 meadway, Bramhall .
bring a friend even if inflatable

 

[BigK]

Why would anyone do that in the first place? Lot of work/material for the average end result.

 

[S a plastering]

coving party at David and rachels 68 meadway, Bramhall .
bring a friend even if inflatable

Haha ya dick that's another job it's in Stalybridge it's just bits I do for a company but keep me busy

 

[A.plasterer]

Haha ya dick that's another job it's in Stalybridge it's just bits I do for a company but keep me busy

 

[flynnyman]

It's run in situ originally ive done three recently and run a couple of lengths on the bench, you could run that in situ but a bit more than half a day.

 

[flynnyman]

They are complete different to coving

 

[Jurek]

i hate coving.

 

[Jaybo1983]

Couple of stop beads then bond and skim.

 

[Marshy]

Haha ya dick that's another job it's in Stalybridge it's just bits I do for a company but keep me busy

Stalyvegas i used to love it there meet loads of characters on the lash

 

[Marshy]

i agree with flynny tell the customer its no dice till they agree new 2day price while doing the rounds in Stalyvegas