I've built an en-suite in the corner of a bedroom and so the new stud walls are dividing the existing coving in two places.
I want to fit coving to the new walls but am struggling to cut the new coving to fit the old at right-angles where they meet, so not a mitre but a T-joint or scribe.
Is there a trick to this or do I cut it as near as possible and then use filler?
Thanks for any advice.
I want to fit coving to the new walls but am struggling to cut the new coving to fit the old at right-angles where they meet, so not a mitre but a T-joint or scribe.
Is there a trick to this or do I cut it as near as possible and then use filler?
Thanks for any advice.