Recent content by Greig

Members online

  1. G

    K Rend and decking

    Hello, i am planning on using K Rend for a garage where there will be decking attached to wall. would it be ok to unscrew outer boards beside wall and K Rend down to the ledger? Then just plane the deck board and screw back down? It's single skin no DPC Might be be a stupid question...
  2. G

    Cementone Render Stablising Primer

    I'm meaning sand/cement as well. Might give it a shot on a small area. I thought that when it said no scratch coat as well. Got plenty to do at my own house so I'll try it and if I arse it up will post back. cheers for the posts though guys
  3. G

    Cementone Render Stablising Primer

    Hi everyone, has anyone used this cementone render Stablising primer before? I've used the green plaster primer stuff before thought it was quite good but never tried this. Apparently it says it eliminates the need for a scratch coat but yet to hear any reviews. It's on the bostik website...
  4. G

    Air bubbles

    Good shout, I'll give that a go thanks
  5. G

    Air bubbles

    Thanks for the help mate, appreciate it
  6. G

    Air bubbles

    Thanks for reply casplas, pretty sure it's air bubbles, some of them are pretty big blisters and others are smaller ones.
  7. G

    Air bubbles

    Sorry. The lighting is crap so the pics aren't good. Not a time served plasterer but I do a lot of skimming. thanks for the reply
  8. G

    Air bubbles

    Hello everyone. I'm patching a couple of bits on a wall just now, with Lafarge ready mix as it's just small cracks but keep getting heaps of air bubbles coming through. Looks like the wall was originally taped and hasn't been painted for a while. From looking at the wall you can tell it's going...
  9. G

    Old Pebbledash

    No chemical DPC holes but ill chip back to the brick in the area to find exactly where it is. thanks again very much for taking the time to reply
  10. G

    Old Pebbledash

    Thanks for the advice, I think I'll strip back to old scratch and SBR. I can't see where the DPC is but if I fit the bell bead about 175mm above floor should that be safe enough? Thanks again, much appreciated Greig
  11. G

    Old Pebbledash

    Hello everyone, I've got a small extension that needs rendering, covered in pebbledash right to ground level. Could i chip off the pebbledash and render over that to the ground or what issues would i have with damp? it's been like that for a good number of years and there's no sign of damp...
  12. G

    PVA question

    Hello everyone, i was just wondering what you guys do in regards to PVA for re-skimming existing plaster. I normally primer coat wait to dry then adhesive coat which is fine for what I'm doing just now as I can crack on with other stuff waiting for priming coat to dry but what do you do if...
  13. G

    patch work

    Thanks for the help guys
  14. G

    patch work

    Hello everyone, I've got a bit of patch work to do in a few ceilings, trying to avoid skimming them all. The ceilings were skimmed years ago. I've screwed in new bits of plasterboard and was wondering should I use couple coats of multi finish then a bit of joint cement to help feather it in...
  15. G

    Skimming over old paint

    Haha cheers, always get carried away when I see new stuff on the shelves
Top