Never used it yet, will have to some day,seems expensiveRenaid it
The best advice I was given was a layer of building paper followed by mesh stops all suction and no cracking at all as its created that barrier but so solid with the mesh
its exspensive but it worksNever used it yet, will have to some day,seems expensive
Any faith in the render grits?its exspensive but it works
sFixed by nails / spit gun/ screws and penny washers does take time but that is in the small print from durrox on rendering on a 3.5 nt block
s
would be happy to go with galv eml ? and 2 or 3 coat render after
Thats would be fine for either, normally 2 coat is sufficient but they suggested the building paper to prevent the cracking either way as its a high suction block and as below 7nts
would be happy to go with galv eml ? and 2 or 3 coat render after
s
would be happy to go with galv eml ? and 2 or 3 coat render after
The best advice I was given was a layer of building paper followed by mesh stops all suction and no cracking at all as its created that barrier but so solid with the mesh