Hi everyone
First time post. I just installed a load of duropolymer coving using bostik gripfill as an adhesive. There are a couple of radiator pipes running along the ceiling that I covered by inverting the coving. I am now worried about the heat of the pipes as the safety spec of the adhesive says do not use near heat sources as it can cause the adhesive to emit carbon dioxide and carbon monoxide. It doesn't specify how hot it needs to get in order for this to happen though. Im a little worried, can anyone offer any advice? I have sent a message to Bostik but can't find a contact number. Any advice greatly appreciated. Thanks
First time post. I just installed a load of duropolymer coving using bostik gripfill as an adhesive. There are a couple of radiator pipes running along the ceiling that I covered by inverting the coving. I am now worried about the heat of the pipes as the safety spec of the adhesive says do not use near heat sources as it can cause the adhesive to emit carbon dioxide and carbon monoxide. It doesn't specify how hot it needs to get in order for this to happen though. Im a little worried, can anyone offer any advice? I have sent a message to Bostik but can't find a contact number. Any advice greatly appreciated. Thanks