I need to fit a piece of coving with an exteral mitre on the left side and the right-had side scribed to an already fitted piece. (if that makes sense).
I have read a thread on here about doing this with a coping-saw - but despite a few hours with a coping saw and sandpaper, I cannot for the life of me figure out what I am doing wrong. I can get a nice snug fit between the 2 pieces, but only if the new piece is about 1cm down the wall from where it is supposed to be!
What am I doing wrong?
I have read a thread on here about doing this with a coping-saw - but despite a few hours with a coping saw and sandpaper, I cannot for the life of me figure out what I am doing wrong. I can get a nice snug fit between the 2 pieces, but only if the new piece is about 1cm down the wall from where it is supposed to be!
What am I doing wrong?