E grade

[Ivor]

spraying e grade tomorrow, any one doing next day scrapes with this ? Cheers

 

[UKPlasteringmachines]

Done some last week went a bit to firm TBH been spraying it this week getting it on early with accelerator in and over HPX and it's been fine

 

[Ianspreader]

Done some last week went a bit to firm TBH been spraying it this week getting it on early with accelerator in and over HPX and it's been fine

You guys using proper k rend accelerator or wickes also what ratio mate

 

[plasterjfe]

I wouldnt think overnight with krend is out the question now if u 2 pass wet in the afternoon but depends where u live i guess

 

[PFTwales]

Generally if the temp is double figures overnight its a same day scrape

 

[UKPlasteringmachines]

Sprayed K1 direct to block work yesterday afternoon was just right this morning for scraping, 7n blocks though

 

[Jgreenplastering]

What's the most common block density used for house building now a days?

 

[UKPlasteringmachines]

Supposed to be 7n

 

[owls]

7n but full of recycled bits of shite that draws in like you wouldn't believe.

 

[owls]

temps are all over at minute 20c today in October never heard of it.

 

[UKPlasteringmachines]

Supposed to be 7n

 

[plasterjfe]

Alot of new hoise builders were doing are using 3.6 n it winds me up but they will not listen

 

[User___removed]

Is there something in writing saying the block should be 7n for render?
Would mind downloading this to show builders

 

[Jgreenplastering]

I think most render manufacturers state something like this on there data sheets .
It's another little gem for them to void the warranty amongst other reasons

 

[plasterjfe]

Is there something in writing saying the block should be 7n for render?
Would mind downloading this to show builders

Yea