beads

[henry]

priceing up small back elevation of a property today. There is three windows and each window nearly sits flush with the brickwork at most is about half inch reveal to fix a bead. I suppose a stop bead would do the job but I dont like the idea of the profile of the bead showing like it would round the window, any suggestions.

 

[Fatarm]

Trim the wing of the corner bead a bit to suit?:RpS_thumbup:

 

[warriorupnorth]

There are reveal beads available mate , one wing much smaller than the other, very handy beads

 

[Andy M]

There are reveal beads available mate , one wing much smaller than the other, very handy beads

Thats great to hear, any links?

 

[DannyMac]

Sometimes if the windows haven't been siliconned you can tap the wing of the bead between the window and reveal, this is assuming it's a new build and the frames aren't as tight as a mouses ear.

 

[warriorupnorth]

Thats great to hear, any links?

DBP do em mate and sure probead do em

Link Removed

 

[flynnyman]

what about bullnosing them?

 

[goody]

I use drip beads on tight windows sometimes just to get it done. If there's a load of tight windows you could run the beads through a tile cutter trimming the wings in advance

 

[henry]

Cheers forthat warrior the winows are more or less flush with the brickwork hence no returns on the reveals. Will walcrete float off to a smooth finish like render.

 

[warriorupnorth]

yes it does mate, an you can scrape it