Recent content by Trowel em up baby

  1. T

    Anyone know we’re I can get hold of one can’t find them anywhere

    I know I didn’t look properly at the size I’ve got bigger rules to sort the bigger areas anyway but cheers arrived now look forward to using it the Refina ones are good but I think the handles on this one are better
  2. T

    Anyone know we’re I can get hold of one can’t find them anywhere

    Thanks for the replies picked one up from O’Neills in the end as I needed it soon as possible
  3. T

    Anyone know we’re I can get hold of one can’t find them anywhere

    Cheers mate I tried to call them the other day to see if it was in stock did they used to be Amaroc??
  4. T

    Anyone know we’re I can get hold of one can’t find them anywhere

    Putz Universal Serrated Derby + Straight Edge
  5. T

    PRB, the Monocouche of Choice | BBA Certified

    Hands down best mono on the market
  6. T

    Parex parlumiere

    It shouldn’t matter we’re you are your sq meter price is what you want to charge can range from 35-55 per sqm depending plus including materials on top.. inexperience will lead you to asking that question.
  7. T

    Mould on new plaster boards.

    There right poor ventilation hot and cold .. just kill it with warm water and bleach not seen it that bad before though..
  8. T

    Monocouche on render carrier boards

    Any know of a brand that will accept it?? Which adhesive / mono?
  9. T

    Wife keen on getting a lazy spar ho tub. I think there to expensive. Anyone got one.

    I’ve got one hope your pockets are deep not cheap to run cost me 20 quid for two goes of the spa which is about 40 mins.. plus it’s got to be on all the time to keep the temp and filters going..pain in the ass to be honest clean down a nightmare too..
  10. T

    Kilsaran GP Render

    Kilsaran was the original krend I believe who had a fallout branded off.. they sell it at the builders I go used there mono nice stuff very similar to krend to be fair
  11. T

    Drying time before re-skim

    It’s normally around 10-15 mins in between the flattening process my guess is your scraping the balls out of it leaving it really thin just apply a little thicker .. should be using minimal water also. Easier said than done but hope it helps
  12. T

    Unibond help

    But they all rinse you dry till you die ..
  13. T

    Webber without bead

    Put a picture up ..
Top