to be honest i think the d4-3 was shagged didnt have my tester with me but it was just to say my d6-3 was fine as i use those all the time so i have a few all the time dont bother with d4-3 that much so no resevre
did a wet dash with cpi today using my g4 the d4-3 wouldnt do it put my d6-3 back in looks great turning a bit fast but two light passes i found better
anybody done much texturing with g4 using weber mono and what setup did you use . done a couple of houses last week with d4-3 and texturing gun with 10mm nozzle still not quite happy still think it needs slowing down a bit any advise thanks . oh i spray 10mm first mesh rule leave hour or so then...
it sounds like you may be best using a weber insulation system to reduce any risk of cracking you could build out the qouins first then they would still stand proud webers m1 leaves same scratch finish the insulation batts can be mechanicly fixed to exsiting wall and bridgeing new work to old...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.