Recent content by southernmanc77

havent really got the depth on door liners etc

hi all if i wanted to s+c a room in my house with dampish walls should i be using waterproofer or just sand cement also pva thank you

hi its a industrial block and not any where a domestic dwelling

sounds good its going to still be a beauy salon after hence needs work ill be honest the block work isnt vey plumb so studs would be lumpy which is why my first thought was wp s+c but with it being shiny paint what would i put on it first to stick i keep hearing sbr being used

im pretty certain its only surface damp as its painted theres no air bricks and its been used as a beaty salon so lots of steam really needed advice on the surface what wouls stick best really and weather to use sbr and if so how also expanding metal???? glossy but not flaky thanks

can anyone advise me if im choosing the right thing out building with 5 inch conc blocks single skin painted inside showing some signs of damp i was thinking maybe s+c with water proofer can a few of you guys run me through the process to detail ie waterproofer sbr how long between coats you...

emulsion and rough facing brick cheers

im a builder i have been floating and setting for a few years now but have never had to float out a painted brick room any advice ie bondind/hardwall pva/no pva ideally i need to set over the same day to make any money but i reckon hardwall would take quite a while to go hence really not keen on...