Recent content by PFTwales

Probably before they had a soft b42 stator

if u put a b4-2 soft stator on the M you can increse its output

DELETE THAT

That bucket clean is great. specially if u work on ur own. it dont splash water about and gets the paddle spotless. My only gripe is that its super heavy when full of water

The swing m is a conveying pump. It would pump and spray airless plaster but not at the controlled conditions or high pressure the swing airless will. You will also need a compressor to blow it on the wall. I would use the 13mm pipe and powercoat gun to apply the material if i was using the...

@Plasterers1StopShop

this is good http://www.pftplasteringmachines.com/product/petrol-megamixer/

110v for show...230v for the pro

Longer cables cause a drop in Voltage and the lower the volts the higher the amps. The higher amps can cause the machine to trip the power supply 110v 32 amp supply with 2.5mm cable can probably stretch 25 mts maybe more however in 230v you could run much longer cables.

Why not submitt a price for what they propose and alternatively what you propose. Then just carry out the work they want done.

The guys machine wouldnt operate properly with a knock off rotor stator, all he has done is replaced knock off for original PFT parts and the machine is running great again. Hes said the knock off shaft is shorter. I went down this route when i first started out and was advised by my PFT...

The d63 soft is about 40 quid plus vat and a bionic mixing shaft about 50 quid. In fairness i think thats cheap. im not sure what knock of equivelant costs

110v mixing pumps are more trouble than they are worth. 2 weeks of phone calls FFS Worse i had was Rob Cleary 4hr phone call and i got him up and running. 230v ritmo L

Great stuff. The beauty of original PFT pumps is the HUGE range of rotors and stators available to choose from. I tried knock offs years ago and they were s**t, so i always stuck with the original PFT ones

So how dis you get on. Did you try a D6-3 soft stator