Recent content by GDS

alright lads might have a bit of work coming up in the next few months around manchester an liverpool . is anyone interested? an what m2 can you do in a day skimming old houses,(multi finish) approx of course depending on the job pm me if you like no prbs

i think it had blown because it had been rendered to the floor and it was cement fllor so water was just at base of wall soaking up when i took blown off it was mainly the bottom half that blown and loose on top half so took all off , the brick underneath was soaking wet i think it was cus it...

an yes i was goin to buy eml for base coat on the wall with old render. can i put scratch on same day as sbr?

sorry what do i do with sbr and at what point? whould i put it on the old solid render also? sorry for silly questions never used it b4. thanks mate

got 2 garden walls to render old render has all blown so will take it all off one of the walls and re do in 2 coats. the other wall has only half blown and the other half is pritty much solid is it possible to remove blown render off this wall and patch up to old and then do one top coat...

haha ok

ow about 6ft 3 doin the average ceiling?

do u think 15-23 inc stilts are too small?

how do you stand up when uv got ya stilts on do ya just pull ya self up the door frame? :)

im the only soft c**t whos got a dead line for wednesday? two 4 bed house's to finish in south liverpool just skimming old lath walls , in box me ya day rate if u want to jump on it with me. any way im off to work !!!!!!!

help!! im the only soft c**t whos got a dead line for wednesday? two 4 bed house's to finish in south liverpool just skimming old lath walls , in box me ya day rate if u want to jump on it with me. any way im off to work !!!!!!!

sorry mate in english?

if you greese the (floral artex pattern) be for taking the mould it will not stick to it the greese will act like a barrier to prevent adesion.

So I take it -1 is is too cold , is there any specifics for when its colder than 8 degrees? Like diffrent mixes or do u add stuff to mix to help get a good finish?

hi , whats the min temp that you can render outside to try to prevent cracking and failing? is there any certin mixer for diffrent temps? its a outside of a house just taking old render off and it neds re doing thanks lads.