Recent content by Dgplastering

On check a trade after rhe client leaves a negative review they can request no further contact from the tradesperson which is ridiculous. Its normally little niggles people moan about and a simple phone call rectigies this rather than hiding behind there review

I got a bad review on checkatrade becuse we didnt clean the clients drive which was mot hardcore lol we did ckean it though at the end of the day you cant please eveyone and people will understand that so i think the odd negative comment is realistic and it doesnt bother me as on checkatrade you...

Hi badger, if the blocks are thermalites (thats what they sound like) you will need a scud coat or id use micro gobetis a parex product to kill the suction. You van always check the suction by chucking some water on them and seeing how quick they dry or do a test panel scratch coat and see how...

@pft Wales I'm looking for a set up for spraying thin coat textures need compressor and gun is the gentilin compressor any good for the money???

I'm using b4 2l on ritmo never had a problem with k1 before we ended up spreading by hand I'm dragging it out tomorrow to have play got some mapei gpr to try

We tried k1 spray last week on ritmo and it clogged up so we scrapped the hopper out and cleaned the r+s to find some dry gear (school boy error) did the same again to find it was wet then dry and kept stopping the mixing shaft like stutter/pause so cleaned it out and no dry powder???? Brand new...

Would love to see if you can texture on the eze 24 I'm not sure if it will work though post a video @Leeroy even if it don't work lol

Lol tell the client it's a rendered finish but the finish shouldn't matter if you spin the performance yarn

It's good for renovation on old stone properties as it can solve a multitude of potential issues and you can charge for it to because you are insulating the property. Barn conversions, old pubs and terrace houses Derbyshire is full of them

I have to say that the bauwer products are really good and we will be using them again. This is light and finish with the talocciato.

Yeah you need to sponge it smooth ya can't Trowell it and won't get it anything like gypsum @Vincey

You can do it in on pass at about 20mm but we had a play and found that it's better to put a pass on and flatten off before a second pass it's quite a bit to get used too also ya can't really rule off large areas as it pulls n tiers so it's best doing 6ft at a time also really soak the walls a...

That was before Christmas so I'm an even bigger c***t now we had it on speed 10 pal @clemo

Bauwer light is to light for standard shaft to mix and force down the chamber or something like that. Sure the monocouche is different

We had to sponge finish the bauwer too can't Trowell it up and we used ritmo l as a conveyor because of the mixing shaft situation. Don't think they do the shafts for the l only g4 g5