Recent content by craigEEE

Sorry, I didn't realise, the more you post the better at your job you are....... Do you fancy doing the job? Be a nice drive from Essex wouldn't it!

If it's towards the Altrincham side of Cheshire we cover that area, we can use either mono or thin coat systems and machine apply. Happy to give recent clients numbers and addresses too to check the work. Fully booked until around April/may though

Which area of Cheshire is it?

Helpful post

I've been asked to do a job (just fitting not supply) 100mm acoustic wool rolls. What are people charging per M²

We went over it again with TC, team of 4 on an elevation of two tubs, for some reason it just kept pulling in quicker than I've ever seen but we got it right this evening

I could handle the defects but it's in a straight line which is annoying, only thing I can think of is a higher suction on this strip maybe the breeze coming off the extension roof or something. Just annoying though as I've never had problems with TC before I'm just gonna give it a paint then...

Yes, fully primed

So today was the 2nd time we've coated it, the joint is in exactly the same place so non of us are sure what's caused it. We all do loads of TC and had a few lads on the elevation so it's not a timing thing but one area just went dry whilst the rest stayed relatively wet. So I just want to know...

Yes

I'm just thinking it will be easier to paint it and I can do that on my own without anyone giving me a hand

I've had a section dry quicker than the rest, and it looks odd, will I just be able to paint over the full elevation to sort it?

Can I just use one coat render or Kmix, for thin coat or does it need to be polymer render, going over brick

Ill send his number if you're interested?

Yes, are you interested? Thanks for the other replies, I've been on holiday so haven't replied