Thanks. Back of sika and febond say 1:1 or 2 sbr to opc. And creamy mix. They do state as you say not to let it dry ( 20mins max) before laying screed on top. assume working in smaller areas?
Thanks
Hi, i need to buy enough sbr and cement for a slurry under a very thin sand cement screed so it is bonded. 18m2. Its replacing an old now removed screed.
Whats the ratio and quantity needed.
Thanks
Tried searching but search engine will not search on sbr for some reason.
Thanks all. Levels were not great and window reveal was onto pb on brick. Face side was insulated board onto brick. didnt have much to nail into hence using the hardwall. Now sorted with some small clouts too. Thanks
Hi, I used a small amount of hand mixed hardwall to secure some beading around a window but it is powdery crumbly now dry so may need to do again.
Did hard wall dry too quick or is it a bad idea to use for small bead?
Used bonding on other windows a month ago and that seemed ok.
Thanks
I have plastered under the stairs but was not happy with the joins between curve and straight run so I have used jointing compound filler ( as used on tapered plasterboard)
Can I make this as hard as the plaster skim coat as I think it may be too soft to take knocks etc ( such as when people...
Hi, one is a spine wall , single skin, internal on concrete ground floor, bitumen applied well over 20y ago but now discovered.
Other is external wall cavity with rock wall (dry inside cavity)
Pics attached hopefully. You will se what I think may be mineral deposit on external brick wall pic...
Hi, House has some minor damp issues where the floor screed bridged the sand and cement wall finish.
After taking a off some very hard patchwork it reveals bitumen type blinded with sand on bricks so looks like an attempt was made over 20 years ago.
Removal of skirting has also removed 2 " high...
Hi, no ive not put in corner yet. It was just that i folded it in my hand and noticed some of them were snapped after folding. Try it. but if not a problem genrally then i will use from a new roll. thanks.
I have some gtec finish paper tape that was going to use on some tapered edge joins.
More skill needed on my part to stick it in corners with multifinish i think though.... ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.