Parinter on paint followed by mono

[User___removed]

Have a job coming up and was thinking of spraying parinter with mesh followed by mono.do you think this is to risky with the weight of the mono?

 

[DannyMac]

You could try a test panel if you're unsure. Give it a few days then attack it with the floor scraper.

 

[PFTwales]

ehi is light weight
did it go ok today

 

[DannyMac]

What's ehi?

 

[goody]

That's what it's for mate.....I'd be tempted to use 10mm beads fixed with parinter in solid bands if its a bit wooly or 15mm on tight if its nice and flat etc. treat it like mono over insulation where the parinter makes up 5mm of the 15mm total, so mono at 10mm max. That's assuming you heed parex's guidelines on the soundness of the paint etc.

 

[goody]

Working with 15mm beads is safer tho when scraped monos the finish....but if your keen enough about making sure no bits of parinter covering the wings of the beads are too high to interfere with the finish 10 might be fine. A brush down as you go should keep things neat, or clean up after parinter spray with a scratchpad around the beads.

 

[spunky]

Do you need a full mesh with parinter I thought you only have to mesh visible cracks?

 

[Arti]

so do you trowel on parinter just like rendaid? does it cost more as well?

 

[DannyMac]

And how keyed do you need to leave it for the mono?

Do you use the normal meshing trowel like this https://www.hilka.co.uk/gfx/products/h-res/66170400_serplastrowelw.jpg

A stipple roller or pull a sweeping brush across it?

 

[owls]

just run a serated h bar over it, plenty of mechanical key.

 

[owls]

Do you need a full mesh with parinter I thought you only have to mesh visible cracks?

5 mm mesh through out.

 

[User___removed]

used it twice now and have meshed both times.would u mono over it owls?

 

[Curry]

Mono over the top is fine. Been using Blanc Du Litter over it all week

 

[User___removed]

nice 1.you said its nice gear to spray steve.how much a bag is it mate?

 

[owls]

Mono over the top is fine. Been using Blanc Du Litter over it all week

whats blanc like over it suction wise?

 

[DannyMac]

Mono over the top is fine. Been using Blanc Du Litter over it all week

How long do you leave it before mono, can you hit it while its still a bit green??

 

[Curry]

whats blanc like over it suction wise?

Fine no issues at all

 

[nickelarse]

just use it like a scratch coat. chuck it on, bed mesh, use a scratcher to give key. top like you would as normal.

iv done it a few times over paint and its fine. just so long as the paint doesnt fall off.....