hi my closest ceiling joist to the wall is 100mm is it ok to 'float ' the board (12.5mm) that far? If not what's the normal maximum for an unsupported edge?
Thanks
Discussed with my renderer about having a monocouche render on my house and having received samples from K-rend told him I liked the silicone FT range.
He said thats fine but its not a monocouche render?
Now i'm i little confused as i thought it was.
He recommended to Weberpral M range...
Great, thanks, was concerned as lots of folks recommend laying board horizontally for strength but miles quicker vertically with large boards.
Didn't think about getting them in but would be room, good point!
Hi All,
Boarding out 2.6m walls any issues with running 2700mm boards and cutting down rather than 2400mm boards?
Never used them before. Just trying to work out and potential problems.
Hi all,
I'm looking for a render job to a newly built extension with 100m2 area (excluding doors/Windows). (6x8x6m by 2 storey with 1 gable)
I was looking at a Krend type but may consider a tradition cement render. Also a small area of rough cast work around a new doorway on existing house...
currently celotexing an oak ridged hipped roof. Got to thinking how the hell am I going to plaster board this thing!?
I can run the boards up the rafters into the hip but when the rafter runs out it will be largely unsupported. I've run a few battens up where I can but is there a rule of thumb...
I've got some spare 4x2 lying around if I rip it in half would 2x2 work? (50mm x 50mm in new money!)
Just discovered it's not level across the join so going to have to pack out the studs anyway.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.