Timber frame job

[Orangemachineman]

Just finished this job for a mate
It's a timber frame build
We used sas pro rend carrier boards with there basecoat LITE used with a sponge finish
The ritmo was used
Really pleased how well it's come out.

Sent from my iPhone using Tapatalk

 

[Cornelius]

Sponge float or normal sponge? I've used prorend before but didn't like it much compared to Webber, how thick you coat that on?

 

[Orangemachineman]

It's 7mm overall
Trowelled flat then hand sponge used


Sent from my iPhone using Tapatalk

 

[mikeweston]

Looks good. I need to re do the rendering on my own place and thinking what to use. Would ideally like to use a pre bagged render. Too much choice. This comes up nice though.

 

[Orangemachineman]

This is a polymer basecoat rubbed up
Not cheap but better than sand & cement over stainless mesh,which will defo crack with the movement


Sent from my iPhone using Tapatalk

 

[themucky1]

Id like to know what their telling him to look for, was it water as he's looking in a bosh


Sent from my iPhone using Tapatalk

 

[Gibbo]

He looks pissed

 

[Orangemachineman]

It's jonsey's mate!!


Sent from my iPhone using Tapatalk

 

[Gibbo]

He looks welsh and pissed then

 

[duke163]

This is a polymer basecoat rubbed up
₩
Not cheap but better than sand & cement over stainless mesh,which will defo crack with the movement


Sent from my iPhone using Tapatalk

Would you spray k-rend hp12 mate ? I'm a bit unsure about the 5 min mixing to activate polymers. Cheers

 

[Orangemachineman]

Its different with a machine due to how the R&s mixes the gear
Everything I use now goes through!!


Sent from my iPhone using Tapatalk

 

[duke163]

Its different with a machine due to how the R&s mixes the gear
Everything I use now goes through!!


Sent from my iPhone using Tapatalk

Thanks , through it goes then !