Rendering mesh

[mikeweston]

Alright fellas. Where would be the best place to get decent rendering mesh. I'm on the Isle of Wight so ideally online.
Have used various ones, last one was from Ebay and was awful stuff, fibre glass splinters for days. Threw it in the end. Jewsons charging £75 a roll for K rend mesh, a little high I was thinking.
Cheers.

 

[keithuk]

Alright fellas. Where would be the best place to get decent rendering mesh. I'm on the Isle of Wight so ideally online.
Have used various ones, last one was from Ebay and was awful stuff, fibre glass splinters for days. Threw it in the end. Jewsons charging £75 a roll for K rend mesh, a little high I was thinking.
Cheers.

Use the one that goes with the material you are using

 

[Dansouthcoast84]

as above your system provider or @plasters1stop

 

[Jgreenplastering]

Keith's right. These cheap mesh rolls are nothing but hassle either, s**t to cut, s**t to lay and there not doing the job there supposed to do. Parex actually accept Weber mesh as an alternative although not sure on vice versa.
For the sake of about a £10er it ain't worth it.


Sent from my iPhone using Tapatalk

 

[Formby plastering]

Have to agree eBay rolls I think we're around 35 absolute load of s**t pay the extra save a lot of hassle and time

 

[mikeweston]

Thanks for the replies. Yeah I soon realised ebay isn't the place. Just thought I'd try one out as sometimes use the mesh internally. What should be the most I should be paying for say K Rend mesh? Just seem to pay through the nose over on the Isle of Wight.

 

[Mag]

Rendit give them a buzz there good

 

[mikeweston]

Cheers Mag

 

[Arti]

Av recently used Johnstones mesh with there thincoat system and its canny gear

 

[Jgreenplastering]

Thanks for the replies. Yeah I soon realised ebay isn't the place. Just thought I'd try one out as sometimes use the mesh internally. What should be the most I should be paying for say K Rend mesh? Just seem to pay through the nose over on the Isle of Wight.

Think around £45-60 most would pay for a render manufacturer mesh.


Sent from my iPhone using Tapatalk

 

[mikeweston]

Cheers JGreen

 

[Dr.B]

Does render mesh go off in any way?
I got an old roll out of the shed the other day and it seemed a little stiffer than the new ones I have? Or is it just the brand?

 

[Jgreenplastering]

Does render mesh go off in any way?
I got an old roll out of the shed the other day and it seemed a little stiffer than the new ones I have? Or is it just the brand?

[emoji23][emoji23][emoji23][emoji23][emoji23]


Sent from my iPhone using Tapatalk

 

[Builderboi]

Does render mesh go off in any way?
I got an old roll out of the shed the other day and it seemed a little stiffer than the new ones I have? Or is it just the brand?

Lol just bring it inside ya plum, it's plastic not fruit

 

[Orangemachineman]

Sas pro rend it decent although a bit dear!!


Sent from my iPhone using Tapatalk

 

[Dr.B]

That's me answered then.

 

[Orangemachineman]

Does render mesh go off in any way?
I got an old roll out of the shed the other day and it seemed a little stiffer than the new ones I have? Or is it just the brand?

Lol


Sent from my iPhone using Tapatalk

 

[Dr.B]

OK OK OK stupid question by me, I get it.