dynamodaveo
New Member
Hi there.
I took to rendering my garden walls and I have to say, I'm very happy with the outcome.
However, half of a section of the back wall was done at a bad time. Not enough time to float, it rained, it got dark. Bit of a disaster. Patchy, mixed finish and looks crap in certain daylight.
So considering I know the mix ratio 4:1 scratch and 5:1 top, not painted, should I
Chip off the good and the bad and go again
Chip off the crap part and try and work to a join
Or can I scar it with a grinder and make a scratch surface to do the whole section again?
I appreciate any guidance or assistance you can offer.
Next time I'll plan better and do the whole section in good time at the same time.
I took to rendering my garden walls and I have to say, I'm very happy with the outcome.
However, half of a section of the back wall was done at a bad time. Not enough time to float, it rained, it got dark. Bit of a disaster. Patchy, mixed finish and looks crap in certain daylight.
So considering I know the mix ratio 4:1 scratch and 5:1 top, not painted, should I
Chip off the good and the bad and go again
Chip off the crap part and try and work to a join
Or can I scar it with a grinder and make a scratch surface to do the whole section again?
I appreciate any guidance or assistance you can offer.
Next time I'll plan better and do the whole section in good time at the same time.