Hi all.
I’ve had a problem with a small panel which thankfully is only 1 bag to redo, and I have a bag left over.
It didn’t set properly and after scratching through the skin it was really soft and as everywhere else is fine I can’t see what I did wrong. But I did put it on in scorching sunshine.
Anyhow I am looking for advice on removing it back to the base coat which is HP12 and doing it again. Any tips or problems doing this as I’ve never had to hack it off again before.
Cheers
I’ve had a problem with a small panel which thankfully is only 1 bag to redo, and I have a bag left over.
It didn’t set properly and after scratching through the skin it was really soft and as everywhere else is fine I can’t see what I did wrong. But I did put it on in scorching sunshine.
Anyhow I am looking for advice on removing it back to the base coat which is HP12 and doing it again. Any tips or problems doing this as I’ve never had to hack it off again before.
Cheers