S a plastering Private Member Nov 29, 2018 #1 Will a circular saw be ok for going through these 50mm boards or a jigsaw tried a handsaw today murder kept jarring the fckers
Will a circular saw be ok for going through these 50mm boards or a jigsaw tried a handsaw today murder kept jarring the fckers
Djr Well-Known Member Nov 29, 2018 #4 I cut the half way down then wedge a piece of Batton between them stop them sticking with a handsaw I use
I cut the half way down then wedge a piece of Batton between them stop them sticking with a handsaw I use
raggles Private Member Nov 29, 2018 #5 You can cut them no bother by hand just stick a wedge in or a Parkside cordless circular saw.
D Deleted member 32554 Guest Nov 29, 2018 #6 Set the saw to 2 mm shy of full depth and cut in situ ( on the stack of boards)
Djr Well-Known Member Nov 29, 2018 #8 Yes as raggles said I wedge wedge them then saw by hand easy enough then
essexandy The Lake Governor Nov 29, 2018 #10 Havagojo said: Set the saw to 2 mm shy of full depth and cut in situ ( on the stack of boards) Click to expand... Nice little tip.
Havagojo said: Set the saw to 2 mm shy of full depth and cut in situ ( on the stack of boards) Click to expand... Nice little tip.
ChrispyUK Well-Known Member Nov 30, 2018 #11 Just fitted a load of 62.5mm pir boards. Handsaw no problem ffs Then again the saw did have a green handle. Probably better than the orange variety...
Just fitted a load of 62.5mm pir boards. Handsaw no problem ffs Then again the saw did have a green handle. Probably better than the orange variety...