Floor on slope, unlevel. help.

Members online

Status
Not open for further replies.

PlasterV

Member
:RpS_unsure::RpS_unsure: I have a floor which was built on a slope I want to level it out, the floor is in a outbuilding. It goes from level to slope at the end of the building, with a slope of over 2 foot down at the back.

I want to level the flooring so I can use it for storage.

There is no DPM in place.

Any advice would be good.
 
Concrete it with dpm underneath, then either screed over with 60mm or use self level. I would do the screed my self..
 
Kango up floor,dig down enough so you can allow for 100mm insulation ,100 mm concrete, 50 mm screed,I know it's storage but why not do it properly
 
We've just done this on a existing garage wall 4 inch jumbo stud with insulation in between the I section then vapour barrier then 60mm Thermaline boards over the top
 
Status
Not open for further replies.
Top