cpi

Status
Not open for further replies.

nickelarse

Private Member
has any1 rendered with cpi in 2 passes same day and floated up outside? over new blockwork?

does it pick up alright? or is it an overnight job in this sort of weather?

ideally sprayed on

cheers
 
I think you'll be ok with that nick ... i havent done it myself but sure you'll be fine as long as its not huge panels
 
yes I have done 3-4 now.

The last one was a disater mind full of hairline fractures. I never did get to the bottom of it but the general thought was it just went off to quick in the sun
 
I have had no slumping at all. Spray the entire panel then empty your pipes into a gorrila tub. then rule off and use the gear from the gorilla to fill hollows if needed. If you rule it to quick it'll sag
 
ill try that out. my max depth is only 15mm, can it be done in one pass straigh on block or is that getting a bit cowboy?
 
the gear was actually pretty good as an ocr. built out really well aswell. did it all in one pass. just takes me 2 hours minimum to get home. and peckham is a dump.
 
Status
Not open for further replies.
Back
Top