Hi all,
I’m blocking up the side of my Internal-doorway in concrete block, I’ll hit off the render around the edge of the existing to carry it over to prevent a joint using Scrim, just wondered what’s the best way to get to a finish coat?
at the moment I’m going to use diluted SBR to prime the wall before I start, give it a good 15mm of render(Holm and cement with sbr in it) then skim tomorrow?
Is this a way I can do it or should I be doing anything different? As I said it’s inside so no damp issues.
I’m blocking up the side of my Internal-doorway in concrete block, I’ll hit off the render around the edge of the existing to carry it over to prevent a joint using Scrim, just wondered what’s the best way to get to a finish coat?
at the moment I’m going to use diluted SBR to prime the wall before I start, give it a good 15mm of render(Holm and cement with sbr in it) then skim tomorrow?
Is this a way I can do it or should I be doing anything different? As I said it’s inside so no damp issues.