1mm dpr as roughcast

[goody]

Heres some pics of 1mm dpr sprayed last year as a roughcast with the swing gun and onboard ritmo compressor. It was an old concrete panel garage that I clad with gtec aqua boards and then maite/mesh etc. hell of a renovation without actually knocking the thing down and building a new garage. Same finish is on the house but that's over parinter/mesh over the old sound dash. Had the wall ties done, a bricked up doorway and the odd repair here and there and looks good as new

 

[johniosaif]

Nicejob

 

[Rigsby]

What is a swing gun?

 

[S a plastering]

What is a swing gun?

It's the hose rigs attached to a machine or compressed that is swung round as you fire the gear on

 

[Rigsby]

Seen this finish in Lord & Downings entrance (PFT Northern), looks like a modern day tyrlolean but a plastic version. I like it but maybe such a finish could be dated?

Anyhow, got some time off next week so any of this stuff being sprayed invite me down for a butchers.

 

[goody]

No this is heavier than that mate...more like traditional roughcast. Bit expensive to use dpr at such thickness but I had a load of tubs accumulated from jobs so was free ish. Maite mixed to dpr consistency is a good possibility but still pricey. Blanc du littoral's got some good potential for a crisp white roughcast but premixed and pumped not mix & spray dry as that's different looking from traditional.

 

[Curry]

What bar does ur Refina compressor hold when spraying continuously

 

[goody]

That's a good question, perhaps blones can remember, it was less than his lk402 when I tested it up there.