Ha ha, had time for a quick fumble between coats!!
For those not reading the thread, I have taken the whole lot down as stated earlier.
Is "Zombie Mix" bonding coat and multi finish mix? please
Used Thistle Multi Finish. Agree and hope Ajax123 is correct and think I'll try again with another coat of pva?
I think I must have been Very lucky in the past because I've never pva'd a ceiling if it's been in good condition and painted. Lucky!
"zombie mix" a mix of bonding and multi...
I didn't pva. Not white on back of what came off, just grooved as artex. I've taken it all off now and pva'd ceiling, do you think this will be enough with another pva before re-skimming?
I'm looking up pre-grit!
Two coats of plaster over lightly combed artex ceiling, both coats dried quickly and a large area came down about two hours later and also a few small areas where it had not bonded properly.
Any advice please?
Any help please. It was down quicker than it went up!! Light combed artex ceiling, nocked off any lumps and plastered. Two coats dried very quickly and came down about two hours later. As far as I know the ceiling has only been painted with emulsion!
Thanks for any help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.