anybody done much texturing with g4 using weber mono and what setup did you use . done a couple of houses last week with d4-3 and texturing gun with 10mm nozzle still not quite happy still think it needs slowing down a bit any advise thanks . oh i spray 10mm first mesh rule leave hour or so then...
the past two days when i set my water it wont go above 300 in the water bottle water pressure is fine as i am working my pump all ok at the minute as rotor nand stator is worn in but when i come to change them prob tommoz i prefer to start up with water a lot higher any ideas would be great dont...
nissan navara drives perfect with roof rack and 12 month old trailer to carry geny and g4 nice clean condition £4,500 map px transit size van must have good engine as travel lots of miles
has anybody used limtec through a g4 i am having loads of probs using 25mm hose 20meters long back pressure is around 35bar can not go any wetter any advise would be great
what would you all say the best way to cure damp after injection i was thinking sbr, coat of sand cement then renovating plaster then skim what are your thoughts
done a 90sq metre ceiling in 6mm stolit k on fri had to use sponge float to apply as no chance with steel trowel anyone got any other ideas on how to apply 6mm on ceilings
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.