Re rendering onto block which is prone to cracking. Want to use a Weber or k rend cement base coat with mesh but then sand and cement render on top. Should this be ok? Looked at using a 10mm mesh with just sand and cement but think this will be hard to cover with he sand. Any suggestions?
Hi All, Just after a bit of help if you can.
Can I use K rend base coat as first and second coat and then just paint it?
I've used it before years ago but was 1st coat with mesh, second coated and then finished with Silicone coloured finish.
Any help would be appreciated! Thanks in advance!
Jon
Hi All!
Just after a bit of feedback if you could!
Just broken into the extension and now ready to start with the internal works. As you can see from the pictures the rooms have been designed to have higher ceilings than normal which I did ask for. Only problem I have now is i'm getting told...
Sorry not really a plastering questions but I'm about to board existing wiring runs and want to make sure everything is in place before it's all done. Electrics are from above so will all be covered over and wont be able to change them.
Some of you may have come across this and the electrician...
Hello,
Just looking to paint new sand and cement render and just wanted to know if anyone had any suggestions for the first coat.
The render has been drying over the last 2 weeks and I just want to get some paint on it to seal it. Anyone use a special sealer or stick with a watered down coat...
On a new build property would it be more common to render the property with the windows in or before the windows are fitted.
I would go with after the windows are fitted as then all reveals can also be finished at the same time.
What is the general rule on this and if rendered before will a...
Hello!
I've been asked to board over an existing fireplace which had the old Baxi boiler in which has now been replaced with a combi system located in the Kitchen. They have asked for it to be boarded over and then patched in with the existing plaster as to keep the mess to a minimum and speed...
Evening all!
I know this is a Plastering forum but considering most people are really helpful I thought I would ask to see if anyone could help!
I'm trying to work out the process of extension footings and up the build to DPC? Does anyone have any knowledge of or know where I could get the...
Hello!
Hope everyone is well!
Just wanted to see if anybody has ever had or still have a Fiat Doblo van and are they any good?
Not looking for anything new just around the 2003 -2004 reg for a start off van and they seem to be reasonable.
Any other suggestions would be helpful!
Thanks
Hello! Hope everyone is busy!
Just after a few tips if possible.
I've been asked to plaster a friends kitchen over the existing artex. Normally I would take off high points, clean, pva then first coat. Let this pull tight leaving for a little longer than normal then on with the second coat...
So I am thinking of adding a few extra tools to my plastering kit and wanted to see if anybody had used the following tools and what peoples opinions were on them!
s*p*r*lex Skimming Spatula V Speedskim Straight Edge?
also
Refina Plastic Finishing Trowel V 20" Stainless steel Finishing Trowel
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.