70%prep 30%skilled work.sorry to say but neither has been done.what the f**k are you going to do about this firm?you have gave them a second chance to put this right and had the piss took right out of you
aye they get you out of trouble done a few overnighters late summer and there great for that hence pads dont last two minutes.weve had a few roofing truss plates made up the same size cheap as f**k.havnt had chance to try them but look identical
good thread I bought one in summer for any dodgy overnighters mono but interested in OCR as I havnt used it for that yet,the scratch pads dont last two minutes on a bad day and expensive as f**k to replace,going to
I bought one in the summer but the eibenstock one,is this the new cheaper one...
as artists says too,I had blockages so keep that gear moving,might be ok winter a would t k ow and do t really want t to neither,personally I would never use it again if possible
we used it for first and only time in summer awful to work with had it on early still on site at half seven,done rest of job round the next corner as an overnight scratched off ok but f**k me it was the wrong decision
I've had golfers elbow on inside couldn't even lift a kettle only thing worked for me was the injection,with in four days it was good to go,dosnt work for everyone so the doc says,this was 4 years ago,just had to have one in my other arm and it's worked too so if if dosnt heal itself I would...
totally agree you here all the skimmers complaining and rightly so when site agents check there work with a light down the side,this shits on a lot heavier and we do our best to leave the best finish we can then some t**t puts a permanent light on there work and expect it to be flawless!a...
always have to have them loosened off and set properly coz they never are,they never use the telescopic ones you can set yourself,hate the f**k**g things!
is this ewi or render only?if its render only it's a grey area depending which clerk of the works you have on site,I've had it where smash them all out,leave all in,only leave above openings but smash the dpc ones out.ultimately it's really down to render manufacturer,I believe parex say you...
ridiculous lighting,totally unfair on any renderer to have them on your work.yeah a few dodgy bits but bh no means a terrible job its them f**k**g lights!!
Done this start of year 1st and only time,couldn't really get in some sort of rythym,might just of been me with it being first try,masking up was no different to hand apply apart from top trim,I would give it another go on the right job,didn't spray second pass just scrim coat
All we done for years was ewi all of the above are right but 9 times out of ten basecoat to thin or havnt two passed it not many ewi systems are one pass,raspings a must to achieve flat walls on new build especially,revites still rasp but your following substrate,we have a mechanical sto rasp...
The barrel was full I was on machine when it happened,I'm swaying towards barrel level with machine,I've always set it up this way,80 bags?standard r&s 20 webber 40 pared j20
Water dropped midspray and wouldn't let me adjust,cleaned out and set up again,it would let me introduce water on set up but soon as I fired up no water at all,Done filters and solenoid,any ideas?
This does all sound a bit wrong somewhere,bit if it's right a reckon I could handle night shift render for the right money for a few months during the winter
My mate just jumped in with a squad a few months ago being the sanding bitch.his opinions are quality finish,but as whats been said before it has to be the right job .hes on one of those fuckoff appartment blocks manchester city centre flying through it.boarding spot on and empty rooms.making...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.