render too low

Members online

kwakarider

New Member
hi there, will it be OK to use an angle grinder to to cut a line in the render horizontally at the bottom of house wall to remove the bottom 4 inch. this would leave no bead at the bottom of the wall.
would this cause any problems ?
will the bead need replacing ?
if so how is best to replace ?
thanks jackie.
 
hi there, will it be OK to use an angle grinder to to cut a line in the render horizontally at the bottom of house wall to remove the bottom 4 inch. this would leave no bead at the bottom of the wall.
would this cause any problems ?
will the bead need replacing ?
if so how is best to replace ?
thanks jackie.




Not ideal .. but if it’s dropping off due to render over dpc ..... run a good straight line to @@ dpc level (Then run hp12 or similar ) up to cut

You won’t replace bead without patching into existing render , would look shite ...

You could turn a stop bead upside down (not ideal).
Then render up to bead in hp12
 
do ye ride a kwaka?
C81EC1BC-9271-4F0D-AB97-A72DE8FDE54D.jpeg
 
j
Not ideal .. but if it’s dropping off due to render over dpc ..... run a good straight line to @@ dpc level (Then run hp12 or similar ) up to cut

You won’t replace bead without patching into existing render , would look shite ...

You could turn a stop bead upside down (not ideal).
Then render up to bead in hp12
the house has is old stone. would like the render on the right to be level with the left side ?
 

Attachments

  • Screenshot_20221127_094032_Gallery.jpg
    Screenshot_20221127_094032_Gallery.jpg
    165.5 KB · Views: 114
j

the house has is old stone. would like the render on the right to be level with the left side ?
Looks like your angle bead meets the horizontal bead (doesn’t look like a bell cast), if so, just cut a straight line and it will match the left side. Is it new render?
Used to have a Z750 hard tailed then a Z1000 - best bike I ever had. I’m a sad c**t without a bike too now.
 
thanks for the advice that's what I will do. 12 month old render not the best workmanship. had 2010 z750 loved it too.
 
Top