you can forget it....
- Thread starter algeeman
- Start date
Gavine The First
Well-Known Member
Quality !
algeeman
It’s A Boy
18" matey.
lurpak
Artex Boy
algeeman
It’s A Boy
essexandy
The Lake Governor
Even he's thinking "look at this piece of flexi shite my rough, onecoat, pikey old man's using". "w**k*r".
algeeman
It’s A Boy
lol
essexandy
The Lake Governor
Actually I made that up. He didn't call you a w**k*r. That was me.
algeeman
It’s A Boy
JessThePlasterer
Queen Jess Elizabeth I
Aaaaaaarrrgghhh he’s trowel sized!!! And his pants match the handle!!!! I’m gonna burst!
algeeman
It’s A Boy
essexandy
The Lake Governor
Good morning young man. Have a good one.
ChrispyUK
Well-Known Member
algeeman
It’s A Boy
ChrispyUK
Well-Known Member
tbf mate, your old chap has put plenty of work in over the last few years, so see it as a well needed rest
algeeman
It’s A Boy
tbf mate, your old chap has put plenty of work in over the last few years, so see it as a well needed rest
1 down 1 to go chrispy
Attachments
essexandy
The Lake Governor
Is that all done with wet angles you lunatic?
If so you need to get back on the booze.
algeeman
It’s A Boy
Attachments
ChrispyUK
Well-Known Member
very nice Algee. I spent yesterday lying on back...under my rusty old van. Knew it needed a couple of patches welding, but there’s more new metal than old now and still loads to do!
algeeman
It’s A Boy
only time I've been under my van mate is when ive fell asleep pished lol
algeeman
It’s A Boy
bit of tender loving care mate
Attachments
John j
Mono Don
Mine went in last week. Said he may as well just order 2 new steps instead of f**k**g about
ChrispyUK
Well-Known Member
same here John. Knew it had a little hole at the front of both steps, but always tip of the iceberg. Got spring hangers to finish off, then ordering 2 steps, inner and outer sill. Quickest way in the end, too fiddly to start patching...just cut the lot out and start again. You can get both sides of eBay for about £160.
kebab king
Private Member
Tidy
John j
Mono Don
Yeah he paid 340 for some. Said they were alot better then the 80 quid ones. .
Lett £500 quid of job I did for him . He.s doing them waxing everywhere up and old change so dont think I can complain
ChrispyUK
Well-Known Member
I reckon it would easily have cost me £1000 to get work done, but I’ve got a few flexible jobs on at mo so can justify using my own time to do it. Usually get most jobs done at garage these days, as I can’t be arsed, but welding is a licence to print money.