Hi,
I did dot and dab and then skim coat at the weekend, its all gone light and only a few darker patches in some places.
When is it dry enough to tighten a bracket on the wall with coach screws going right through into the brick wall behind - for a radiator?
When doing the dot and dab I put...
Thanks reeves,
Well after a knackering day i cover about 12sqm of the conservatory. I'm pleased with most walls. But unfortunately I did the big wall first 1.8m x 4.2. It turned out ok but was a nightmare to keep up with the drying of the drying times.
Will see when it goes lighter but I can...
I was going to do that but it's my first time since I did a course. Will be as quick as I can but thought it was better to mix fresh after the first coat? Didn't want it to end up too stiff. I guess if it was then I could just throw it away and mix up a new load :)
hi,
I know 25kg of multi finish covers about 10sqm.
My wall is 8sqm so given the second coat is thinner how much of a bag to I mix up for the first coat? A bit more than half or 2/3 ?
Cheers!
Cheers guys, nails will probably be it. Like the idea of staples though, if using staples do they have to be galvanised (if such thing exists) or just ordinary? And I won't be shooting out to whsmiths :)
never heard of hook on beads but sound good!
Hi,
I'm fitting my angle beads soon ready for a skim onto plasterboard this weekend.
How do you guys normally fix them? I was taught to nail them but can you use drywall screws? I had a look and as the screw head is tapered I think it might stick out too much, unless it pulled in when you...
Hi,
I will soon be plastering a room in my house, just wondered any recommendations on different types of corner trowels?
I've got a Marshalltown trowel and i've seen those flexible corner trowels they also do, I can see they are not 90 degrees but may get a nicer finish as I guess you have to...
The date on the krend bag is the production date, not the end of life date
http://www.k-rend.co.uk/pdf/bba-cert-com-rend.pdf
2.4 Each bag bears the manufacturer’s mark, batch number and date of production. Each pallet bears the BBA identification logo incorporating the number of this Certificate.
Hi guys,
Had a krend job done and a stop bead was installed at DPC level with a belcast bead underneath and then also rendered below the DPC level.
The stop bead was set in slightly further to the wall and was rendered over and bell cast bead was left exposed.
Just wondered if thats normal...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.