The background was old plastered wall. Previously wallpapered and painted over. Had been up for a long time. When pva was put on some bits dried out quickly. I put more on until tacky. Wondered if an open window could have contributed this to happening.
Plastered a wall in with multi 2 coats and when dry noticed a couple of patches with many small holes on it. Any idea what causes this . Had some problems with wall drying quicker in some bits than others but leaving a window opened on a hot day may not have helped. Had pva with primer coat then...
I find the ragni carbon steel trowels I have start to corrode and get marked very quickly any time I use it. They are only used occasionally. I clean them after use each time. Is there any way I can stop this from happening.
Thanks
Top part of wall is board. Most is brick. The band is about a foot from top of room. The band is sitting on top of brick. The top edge joins on to the board if that makes sense. Band only about 3 inches wide
Stripped a wall and found a dark grey band round the wall. It appears to be used to level out the wall in the same way an bonding would be used now.
I know it is a vague description but curious to know what it is an if it is ok to skim over.
It was put up quite a long time ago.
My normal work is an electronic technician contractor but industry quiet at moment. Just do occasional plastering but not on a commercial basis and very much one wall at a time.
Stripped a room today ready to skim. One wall had plasterboard with brown side out and unpainted . It has been on for 10 plus years. I believe this was normal at the time. Wondering if it is ok to just pva and skim on this surface. This is just a small diy project
Cheers
Been on this site for awhile and thought I would say hello.
Very good site with lots of good information. Not a plasterer myself although done some in a diy capacity.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.