Alryt lads
iv got about 100m2 of external rendering to do, it's approx 2 x 50m drops. It's onto thermalite block were previous failed render has been hacked off!
I am going to put an sbr slurry over it first and was looking for some advice.
would you mesh it aswell?
sbr mix ratio?
do you leave...
done 80m2 of lath an plaster ceilings in November/December, to be honest it's hard work, but it's not to bad. A nail gun and compressor are a must for lath ceilings! And I would advise that you do it on a day rate!
Evening all! I'm going to buy a couple of new skimming trowels this week, I'm used to marshalltown but fancy a change, just wanted your thoughts on the kraft elite series?? I like the look of them but don't no if they are any good?? Or should I stick with MT?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.