Recent content by GARZX9R

But which of the base coats would you recommend, is that yes to wetting down or priming with sbr

Hi, what's the best base coat from KRend to go over thermolite block work, is wetting down needed, or priming with an sbr etc, cheers

Quick question lads, scratcher, different length needles, what's the reason, some are straight some come twisted,

Got ya, cheers

Once ruled off and left to dry ready for scratching, is going over with the I beam done right before the scratch or earlier

Got the mesh,

I've just built a extension onto our kitchen, thought I'd give the render a go myself, always done the internal stuff myself, got some k1 top coat, what's the best base coat to use over thermalite? Shall I just wet down before hand or prime the blocks with something, cheers

Howway man, gis a link, all I'm finding is links to make up. You know the type you have on when your out with your lasses clothes on, with the little glint in your eye when your vibrating butt plug is on max.

Can you gis more details m8, have you got a link to where I can get it

I've got some S&C render where the paint has come off and the render has gone powdery, what's the best way to sort it? Hack off areas of concern and re-do or is there a quicker way, cheers

Oldroyd is on but dot and dabbing isn't an option as the board is protruding past wall finish above even without adhesive, don't fancy hacking off above to dot and dab to ceiling, can always use sand, cement, but I was wondering if it's ok to use bonding coat etc, would appreciate advice please

There's always one

So if I use a tyrolene gun it'll obviously go on, on thin passes, the existing is approximately 15mm thick, what would you's recommend as a Base coat to apply the tyrolene to.

Hi, I've got a section needs matching to existing property which is a fine finish tyrolean, I haven't got the gear to spray on so I was thinking would putting stucco on finished off with a roller give a similar finish, not an expert on external rendering etc so would appreciate your views, cheers

I've got a little repair to do on some k rend, it was knocked at the corner, bead needs replacing etc, don't normally do external work, or very rare, what's the best stuff to stick the plastic beads on with