Recent content by g5johnney

  1. G

    Parex or k rend

    first i would presure wash the old stone dash down which will get rid of any lose stones and clean substrate then check reveals can take 15mm of new render if not these will have to cut back to brick or block then check there are no hollow areasif there are they need to be cut and repaird before...
  2. G

    g4 for sale south east

    yea i can get some if req but only if intersted in machine
  3. G

    g4 for sale south east

    hi mate the machine is 2001 but u would not think so its only been aspare machine 4us used it a handfull of times 2/3 hours aday its avery clean machine this has not been abussed as ilook after all my machines unlike some pepole out there
  4. G

    g4 for sale south east

    the machine is 3200 all in iam in bedfordshire mate
  5. G

    g4 for sale south east

    this machine has been totally refurb new water pump newtie rods with hex nuts presure flange d pump 35mm new air pres switch water pres switch comes with 30mts of hose 25mm mixing shaft manometre cleaning tool 1 short gun 1long this machine is fully working and ready 4 work any insepec wellcome
  6. G

    Genplus systems generator 15kva for sale

    what year is it and how many hours has it done
  7. G

    g4 for sale south east 3000

    going to get another newer g5 so ive got spare caddy for either machine rather have spare caddy in van than 2machines
  8. G

    Genplus systems generator 15kva for sale

    where are u based fella
  9. G

    g4 for sale south east 3000

    this machine has been refurbished totaly at pft northern to many parts to list looks and runs like new and ready for work
  10. G

    a machine that spray`s sand &cement.

    a putzmeister p11 or p13 will do the job u need to different types of sand and include lime u can put wallpaper paste throu hoses and collect inbucket to use again the next day these machines will mix :RpS_thumbup:and pump the sand and cement or u can try cpi bagged sand and cement render
  11. G

    anyone used the dashing gun and compresser from les at pft

    far less than with aharling trowel and bucket if your worried about rebound make astrecher up to catch stones and put back in bucket or dashing gun you do this after your top coat then all the stones stay clean
  12. G

    a technical question ??

    the mesh should be inthe top third of base coat rule base coat with serrated rule then spat the mesh in top third of surface
  13. G

    all you machine renderers

    alot of ulads who run electric machines dont forget to drain down your machine ohterwise you will have prob when going back after frost :RpS_drool:
  14. G

    anyone used the dashing gun and compresser from les at pft

    pft northern dashing gun Ive seen the test panel les done very even and no problems with getting round saffold poles
  15. G

    anyone used the dashing gun and compresser from les at pft

    go on utube and type inpft northern dashing gun its the nuts
Top